I was thinking about swimming pool heat pump service problems today. My favorite models have the least issues of course. They are still just machines, and sometimes they need to be repaired. Some of my favorite brands that I sent out 15 to 20 years ago are still running and have never been touched by a mechanic. I hope that the ones that I like now will have the same performance. That isn’t too good for my business model now but maybe customer referrals will make up for that. A pool is supposed to be fun and relieve stress and not cause you stress with operational problems. My goal has always been to have give people a comfortable pool that they can use for the longest possible time where they live. The most common call that I get is that there are no unions included on their new heatpump. The unions are inside the access panel usually taped to a PVC pipe so that they don’t get lost of or broken in shipment. The next most common call is that the heat pump is leaking water. 99.9% of the time that is normal condensation that is caused when you take heat out of the air to put in the pool you bring the air below the dew point and water then drips out of the pool heater. The more water on the ground the better the heat pump is heating. If you are ever in doubt that it is condensation you can test it with a chlorine strip to see if it reacts to pool chemicals. If no reading than you are fine. You can also turn the swimming pool heat pump off for a day to see if the area dries out. If it does dry out then everything is normal. Tripped breakers and blown fuses are common. Check that before you pay for a service call on your heater. Most issues are flea type things. The big elephant repairs are pretty rare. I think one in 5000 pool heat pumps lose a compressor. That could be a figure from the air conditioning / heating industry but I am sure it is close. Fan motors on pool heaters sometimes fail. Many times that is because they are installed just under the drip edge of the roof. They are designed to be outside for 15 years but are not designed to get a flood of water from the roof during a rain storm. If you have no choice and can’t move it then maybe put a 6 foot gutter over the heat pump. Electrical controls like contactors and relays are taken out by ants many times especially in the South. I have even seen a opossum and huge frogs in the control panel. They got in their when they were little and then grew too big to get out. You might have to seal up some holes when that happens. Not on my new heat pumps though. They are pretty well sealed up. If it starts raining frogs then you have bigger problems than your pool heater and I would take cover inside. If anyone has any trouble shooting questions please write, text or call and I will try to help out.
Keep swimming. It is great exercise and lots of fun.
I am on your side.
Marcus Cell 360 348 7574